satco/nuvo

3 inch brass-plated check ring in straight-edge steel, bored 1/8 IP slip. The larger diameter and flat profile work well as a base trim or shoulder...

Steel check ring at 3-1/4" diameter, brass plated for a warm finish that coordinates with brass fixture hardware. Straight edge and 1/8 IP slip thr...

Straight-edge steel check ring measuring 1-5/8 inch in diameter, sized to slip over 1/8 IP lamp pipe with a flat, squared-off profile.Features Stam...

Stamped from steel with a flat, straight edge, this 1-7/8 inch check ring slips over 1/8 IP lamp pipe and is finished on site.Features Stamped stee...

Straight-edge check ring in a 2 inch diameter, stamped from steel and sized to slip over 1/8 IP lamp pipe.Features Stamped steel construction Strai...

A 2-1/2 inch straight-edge check ring in unfinished steel, sized to slip over 1/8 IP lamp pipe for shade retention or decorative capping.Features S...

This 2-1/4 inch check ring is stamped from steel with a straight edge and a 1/8 IP slip fit, left raw for custom finishing.Features Stamped steel c...

Retain a shade or cap a decorative nipple with this 2-1/8 inch steel check ring, machined with a straight edge and 1/8 IP slip fit.Features Stamped...

Steel check ring at 2-3/4" diameter with a clean straight edge, sized for 1/8 IP slip lamp pipe. Unfinished surface accepts paint, plating, or lacq...

A 3-inch steel check ring that bridges the gap between a 1/8 IP nipple or socket and the shade above it, giving lamp builds a clean, finished trans...

Cap a larger lamp pipe assembly with this 3-1/2 inch steel check ring, machined with a straight edge and 1/8 IP slip fit.Features Stamped steel con...

Straight-edge steel check ring in a 3-1/4 inch diameter, sized to slip over 1/8 IP lamp pipe and left unfinished for custom coating.Features Stampe...

This 3-3/4" check ring locks a glass shade or diffuser against a fixture body via a 1/8 IP slip thread, holding the glass square and preventing rot...

Unfinished steel check ring with a straight edge and 1/8 IP slip, used as a finishing washer or retention ring in lamp assembly. The 4" diameter an...

This 4-1/4" check ring locks a glass shade or diffuser against a fixture body via a 1/8 IP slip thread, holding the glass square and preventing rot...

A 1-inch steel finial with a brass-plated finish — the workhorse cap for finishing off lamps and small fixtures without paying solid-brass prices. ...

A 1-1/2 inch steel finial with a brass-plated finish, giving lamp tops a fuller profile than the standard 1-inch cap. The 1/4-27 thread is the ligh...

Larger-scale 1-1/2 inch nickel steel finial for lamps that need a more visible top detail. The polished nickel plating pairs naturally with brushed...

A compact 1/2-inch steel finial with brass plating — the right cap when a full-size finial would look out of scale on a small lamp top or a delicat...

Nickel-plated steel finial in a compact 1/2 inch diameter, designed to top off lamp harps and shade assemblies with a clean, polished accent that c...

At 1/2 inch body length with 5/8 inch overall, this brass-plated steel nipple covers the mid-range spacing between fittings that shorter nipples ca...

Brass-plated steel construction gives this 1/8 IP hex-head nipple a durable finish for lamp assemblies where hardware may remain visible. The 1/4 i...