Fixture Accessories

One-inch 1/8 IP steel nipple with a yellow zinc-plated finish, long enough to bridge a deep canopy or clear a stacked check ring and washer assembl...

Pull-chain glazed porcelain ceiling receptacle, a self-contained utility fixture that mounts directly to a ceiling box and includes its own on-off ...

Pull-chain GU24 flush mount fixture with a squat urea housing and a twist-on Lexan lens, sized for closets and utility spaces where a wall switch i...

Inline on-off cord switch designed to install midway along 18/2 SPT-2 lamp cord, giving table lamps, floor lamps, and accent fixtures a convenient ...

Standard 1/8 IP steel nipple in zinc plated finish, 60 inch length for stem-hung pendants and chandeliers dropping from tall residential and light ...

Heavier 3/8 IP steel nipple, zinc plated, cut to 48 inch length for larger chandeliers and commercial pendants that need a wider-diameter stem to c...

72 inch steel nipple threaded 1/8 IP end to end, finished in bright zinc for use in stem-hung pendants and chandeliers over very tall spaces. Cut t...

Long 60 inch steel nipple with 1/8 IP threading and a yellow zinc plated finish, used where a fixture stem needs to span from a high ceiling down t...

Yellow zinc plated steel nipple with 1/8 IP threading, cut to 30 inch length for long stem hanging fixtures, extended pendants, and vertical drops....

Keyless glazed porcelain socket with 9 inch AWM leads, built for high-heat applications where a plastic-bodied socket would degrade. The glazed por...

Replacement paper liner sized for short keyless sockets, installed between the socket shell and the outer cap to insulate the shell contact and pre...

Pull-chain GU24 flush mount fixture designed for spaces without a wall switch. The squat urea housing keeps the profile low against the ceiling whi...

Cast brass screw collar loop finished in nickel, threaded 1/4 IP for standard lamp assemblies. A sturdy hanging attachment for pendants and drops w...

Brass-plated steel riser used as a spacer or decorative extension in lamp assemblies. The 1/4-27 thread matches finials and thread caps, and the pl...

Extra-long 50 inch steel nipple in 1/4 IP thread with a zinc-plated finish. Standard drop-tube length for pool table lights, kitchen island pendant...

Cream plastic candle cover that slips over a candelabra socket to give chandelier and sconce fixtures a traditional candle silhouette. Slightly war...

Porcelain-bodied GU24 ceiling receptacle built for higher-heat applications, with an integrated pull chain switch and pre-wired 6 inch black/white ...

Convert a bare-bulb GU24 socket into a switched ceiling fixture with this white phenolic pull chain receptacle. Screw terminals keep wiring straigh...

Unfinished 1/4 IP steel nipple in the 48 inch long-run length, ready for plating, painting, or hidden runs where the raw finish never shows. Same 1...

Long-run 1/4 IP steel nipple in a 48 inch length, zinc plated for corrosion protection where a threaded stem needs to travel through decks, canopie...

White plastic candle cover sized for medium-base sockets, at 1-3/4 inches tall with a wider 1-1/4 inch outside diameter. The short profile suits fl...

Light duty 15 inch harp in polished nickel for medium and smaller shades that need a slimmer frame. Ships with the standard 1/8 IP saddle and 1/4-2...

Light duty version of the 15 inch harp in polished brass, sized for medium to smaller shades that don't need heavy gauge support. The slimmer profi...

The polished nickel version of the 15 inch heavy duty harp, giving contemporary and transitional lamps a cooler-toned frame to pair with brushed or...